Bauknecht WATK Prime 10716 Use and Care Guide download pdf (Page 15)

15

EN

Dry only

This function is used to simply dry a wet load

washed previously in the washer dryer or by

hand.

1. Select a suitable programme for the laundry

you want to dry (e.g. select cotton to dry wet

cotton laundry).

2. Press button to dry without a wash cycle.

3. Press to select the required drying mode. Two

drying modes are available: automatic drying by

levels or drying by time.

- Automatic drying with selectable levels:

In automatic drying mode, the washer dryer

machine dries the laundry until the set level of

dryness is reached. Pressing button once

automatically selects the highest drying level

available for the selected programme. Press the

button again to reduce the drying level.

The following levels are available:

Cupboard extra dry : suitable for garments

which need to be dried completely, such as

sponges and bathrobes.

Cupboard dry : laundry is completely dry and

ready to be put away in the wardrobe without

ironing.

Hanger dry : laundry is left slightly damp to

minimise creasing. Garments must be hung to

air dry completely.

Iron dry : garments are left reasonably damp

to make ironing easier.

- Timer drying mode:

Press button repeatedly to set timer drying

mode. After cycling through all the automatic

drying levels, continue pressing button until

the desired time is displayed.

Values from 180 to 30 minutes are settable.

N.B.: always allow a cooling down period after

drying before opening the door.

5. USING THE CORRECT AMOUNT OF

DETERGENT. Pull out the tray and pour

detergent into the relative compartments

as described in “Detergent dispenser”. This is only

necessary when using a wash only or a wash +

dry programme.

6. DELAYING THE START OF A PROGRAMME. To

set a programme to start at a later time, see the

section “Programmes and Options”.

7. STARTING A PROGRAMME.

Press the START/PAUSE button. The relative

indicator lamp illuminates, the door locks

and the door open symbol extinguishes.

To change a programme while a cycle is in

progress, press START/PAUSE to pause the

washer dryer (the START/ PAUSE lamp ashes

amber slowly); then select the required cycle

and press START/PAUSE again. To open the

door while a cycle is in progress, press START/

PAUSE; the door may be opened if the

symbol lights. Press the START/PAUSE button

again to resume the programme from where it

was paused.

8. CANCELLING A RUNNING PROGRAMME IF

NECESSARY

Press and hold the button until the washer

dryer stops.

If the water level and temperature are low

enough, the door unlocks and may be opened.

The door remains locked if there is water in the

drum. To unlock the door, switch the washer

dryer on, select the

programme and turn the spin function o

by setting the spin speed to “- -“. The water is

emptied and the door unlocks at the end of the

programme.

9. SWITCHING THE WASHER DRYER OFF AT THE

END OF A PROGRAMME.

At the end of the cycle, the message “Cycle end”

is shown on the display. The door can only be

opened when the symbol lights. Check that

the door unlocked symbol is lit, then open the

door and take out the laundry.

Press to switch the washer dryer o. To save

energy, if the washer dryer is not switched

o manually with the button, it turns o

automatically approximately 30 minutes after

the end of the programme.

Leave the door ajar to let the interior of the

washer dryer dry.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 38 39

Comments to this Manuals

No comments