14
HOW TO USE THE WASHER DRYER
1. LOADING LAUNDRY.
•Prepare the laundry, following the
recommendations given in the section
“HINTS AND TIPS”. - Open the door and
load the laundry into the drum, without
exceeding the maximum load capacities
indicated in the Programmes and Options.
•Close the door, pressing until the latch
audibly locks, and check that there
is no laundry trapped between the
door glass and the rubber seal.
2. OPEN THE WATER TAP
Check that the washer dryer is connected
correctly to the water mains. Open the water
tap.
3. SWITCHING ON THE WASHER DRYER
MACHINE.
Press button ; the lamp ashes slowly.
4. SELECTING A PROGRAMME AND
CUSTOMISING A CYCLE. The following
functions are possible with this appliance:
•Wash only
•Wash and dry
•Dry only
Wash only
Select the required programme with the
PROGRAMME selector dial. The display will
show the name and duration of the cycle. The
washer dryer machine automatically displays
the maximum temperature and spin speed
settings possible for the selected programme.
Adjust the temperature and/or spin speed
settings if needed with the relative buttons.
•Press button to cycle through
progressively lower temperature settings
until cold wash is set (“- -“) shown on display.
•Press button to cycle through
progressively lower spin speed settings until
the spin cycle is turned o (“- -“ shown on
display).
Pressing the button again sets the highest
possible setting.
Select the required options (if necessary).
•Pressthebuttontoselecttheoption;the
respective button lamp illuminates.
•Pressthebuttonagaintocanceltheoption;
the lamp extinguishes.
! If the selected option is not compatible
with the programme set, an error warning
tone sounds and the wording “No Selection”
is shown on the display. The option is not
selected.
Wash and dry
To wash and dry a load with no interruption
between the wash and dry cycles, make sure
that the load does not exceed the maximum
permissible drying load for the selected
programme (see the column “Max. drying load”
in the Programmes and Options).
1. Follow the instructions given in the
paragraph “Wash Only” to select and,
if necessary, customise the required
programme.
2. Press to select the required drying mode.
Two drying modes are available: automatic or
timer.
- Automatic drying with selectable levels:
In automatic drying mode, the washer dryer
machine dries the laundry until the set level
of dryness is reached. Pressing button once
automatically selects the highest drying level
available for the selected programme. Press
the button again to reduce the drying level.
The following levels are available:
Cupboard extra dry : suitable for garments
which need to be dried completely, such as
sponges and bathrobes.
Cupboard dry : laundry is completely dry
and ready to be put away in the wardrobe
without ironing.
Hanger dry : laundry is left slightly damp to
minimise creasing. Garments must be hung
to air dry completely.
Iron dry : garments are left reasonably
damp to make ironing easier.
- Timer drying mode:
Press button repeatedly to set timer drying
mode. After cycling through all the automatic
drying levels, continue pressing button
until the desired time is displayed. Values
from 180 to 30 minutes are settable.
To wash a load of laundry larger than the
maximum permissible load for drying (see the
column “Max. drying load” in the Programmes
and Options), remove a few garments once the
washing cycle has nished before starting the
drying cycle. Proceed as follows:
1. Follow the instructions given in the paragraph
“Wash Only” to select and, if necessary,
customise the required programme.
2. Do not include a drying cycle.
3. Once the washing cycle is nished, open the
door and remove a few garments to reduce
the load. Now follow the instructions for
“Dry only”.
N.B.: always allow a cooling down period after
drying before opening the door.
When using the two preset cycles and
, it is not necessary to select and start a
drying cycle.
Comments to this Manuals