Bauknecht CM 945 PT Instruction for Use Page 1

51 mm65 mmCM 945 PT

Always clean tubes inside milk container after use - Risk of poisoning.During rinsing, hot water is spilled from the coffee spouts. Avoid contact with

Built-in installationCheck the minimum measurements required for correct installation of the appliance.The coffee machine must be installed in a colum

12Secure the power supply cable with the clip provided. The power supply cable must be long enough to allow the machine to be removed from the housing

13ApplianceSee image A on page 4.A1 Cup trayA2 Service doorA3 Coffee feedA4 Coffee grounds containerA5 Brewing unitA6 Cup tray lightsA7 On/stan

• Coffee has been used to factory test the machine and it is therefore completely normal for there to be traces of coffee in the mill.• Customize wa

151. The machine is factory-set to make coffee with a standard taste. You can choose coffee with the following tastes: extra-mild, mild, standard, st

16The appliance is factory-set to automatically deliver the following amounts of coffee:• Espresso,• Small cup,• Medium cup,• Large cup,• Mug.To mo

Running off hot water 17• Always check that the machine is ready for use.• Check that the water spout is attached to the nozzle (Figure 6).• Place

18N.B.:• While making cappuccino, you can stop frothed milk or coffee run-off by pressing the button (B10).• To keep the milk frother hygienically

Setting the languageTo change the display language, proceed as follows:• Press the MENU button (B2) to access the menu and then buttons (B5) and (

Setting water hardnessIf desired, the interval between descaling cycles can be increased so that descaling is performed less frequently and in accorda

Energy saving• Press the icon (B2) to enter the settings menu.• Press the icons (B5) and (B6) until ENERGY SAVING is displayed.• Press the icon

22The drip tray has a water level indicator in the form of a red float (Figure 27).Empty and clean the drip tray before the red float protrudes from t

23N.B.: If you encounter difficulty inserting the brewing unit, before inserting it adapt it to the right size by pressing it forcefully from both the

Displayed messages24DISPLAYED MESSAGE POSSIBLE CAUSE REMEDYFILL TANK !- The water tank is empty or incorrectly positioned.- Fill the tank with water a

Troubleshooting25Below is a list of some possible malfunctions.If the problem cannot be resolved as described, contact After-sales Service.PROBLEM POS

400011132419Printed in Italy10/2017EN

Instructions for use 26

4ABC

5

6

7Safety instructions 8Important to be read and observed 8Installation 9Electrical warnings 9Cleaning and maintenance 9Safeguarding the environment

8Safety instructionsImportant to be read and observedBefore using the appliance, read these safety instructions. Keep them nearby for future reference

This appliance is not for professional use. Do not use the appliance outdoors.Do not store explosive or flammable substances (e.g. gasoline or aerosol