Bauknecht WATK Prime 8614 Use and Care Guide download pdf (Page 29)

TROUBLESHOOTING

The washer dryer may sometimes not work properly for certain reasons. Before calling the Support

Centre, it is recommended to check to see if the problem can be easily resolved using the following list.

Anomalies: Possible causes / Solution:

The washer dryer does not

turn on.

• Theplugisnotinsertedintotheelectricaloutlet,ornot

enough to make contact.

• Therehasbeenapowerfailure.

• Thedoorisnotfullyclosed.

The wash cycle does not start. • TheON/OFFbuttonhasnotbeenpressed.

• TheSTART/PAUSEbuttonhasnotbeenpressed.

• Thewatertapisnotopen.

• Astartdelayhasbeenset.

Wash&Dry does not ll with

water (the LED on the rst

wash stage and the LED on the

START/PAUSE button ash).

• Thewaterintakehoseisnotconnectedtothetap.

• Thehoseisbent.

• Thewatertapisnotopen.

• Themainswatersupplyhasbeenshuto.

• Thereisnotenoughpressure.

The washer dryer loads and

drains water continuously.

• TheSTART/PAUSEbuttonhasnotbeenpressed.

• Thedrainhosehasnotbeeninstalledat65to100cmfrom

the ground.

• Theendofthedrainhoseisimmersedinwater.

• Thedrainconnectoronthewalldoesnothaveanairvent.

If the problem persists after having performed these

checks, close the water tap, shut o the washer dryer, and

call the Support Centre.If the dwelling is located on one

of the uppermost oors of a building, a siphon eect can

sometimes occur, thus causing the washer dryer to load

and drain water continuously.Special anti-siphon valves are

available on the market to prevent these types of problems.

The washer dryer does not

drain or does not spin.

• Theprogrammedoesnotincludethedrainingfunction:with

certain programmes it must be activated manually.

• Thedrainhoseisbent.

• Thedrainlineisobstructed.

The washer dryer vibrates

excessively during the spin

cycle.

• Atthetimeofinstallation,thedrumwasnotproperly

unlocked.

• Thewasherdryerisnotlevel.

• Thewasherdryerissqueezedbetweenfurnitureandthewall.

The washer dryer leaks water. • Thewaterintakehosehasnotbeentightenedproperly.

• Thedetergentdispenserisclogged.

• Thedrainhosehasnotbeenproperlyfastened.

Two of the four LEDs for

“Wash&Dry Stages” are ON

steady and the other LEDs on

the control panel ash rapidly.

• Shutothemachine,disconnecttheplugfromtheoutlet,

and weight about 1 minute before turning it back on.

If the problem persists, call the Support Centre.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 37 38

Comments to this Manuals

No comments

Bauknecht WATK Prime 8614 Use and Care Guide Page 29

Comments to this Manuals

Related products and manuals for Washing machines Bauknecht WATK Prime 8614