Bauknecht KGNF 18 A3+CONNECT Use and Care Guide Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 38
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
18
The Active 0 compartment is
specifically designed to maintain a low
temperature and a suitable humidity
level, in order to keep foods fresher for
longer (e.g. meat, fish, fruit and winter
vegetables).
ACTIVATING AND DEACTIVATING THE
COMPARTMENT
To activate/deactivate the Active 0
compartment, press the dedicated
button on the control panel ( indicator
in the figure below).
Active 0 compartment off:
button partially lighted
Active 0 compartment ON:
button fully lighted
When activated, the lighting bar on the
Active 0 compartment lights up.
The temperature inside the
compartment/drawer, when active, is
approximately 0 degrees.
The following factors are vital for the
compartment to work properly:
- the temperature of the refrigerator
compartment must be switched
between +2 °C and +4°C.
- the compartment must be inserted to
enable activation
- no special function must have been
selected (as Standby, Vacation
mode – where applicable).
If one of these special functions has
been selected, the fresh food inside
the Active0 compartment should be
removed.
Note:
if the lighting bar and symbol does not
light up but the the symbol blinks when
the box is being activated, check that the
box is properly inserted; When the drawer
is inserted, the function is able to activate
again after few seconds by simple pressing
the button. if the problem persists, contact
your nearest authorized After-sales Service
if the Active 0 compartment is active and the
drawer is open, more than 2 minutes, the
function is deactivated automatically.
After the drawer is inserted, the function is
able to activate again after few seconds by
simple pressing the button.
irrespective of the state of the box, a slight
noise may be heard: this is normal and is not
a cause for concern.
when the box is not active, the
temperature inside it depends on the
general temperature inside the refrigerator
compartment.
In this case, we recommend it is used to
store fruit and vegetables which are not
sensitive to cold temperatures (fruits of the
forest, apples, apricots, carrots, spinach,
lettuce, etc.).
Important: when the function is activated
and there are foodstus with a high water
content, condensation may form on shelves.
Attention:
Incompatibility with the
“Vacation” function
To guarantee optimal performance,
the “Vacation” and “Active 0” functions
cannot be used at the same time.
Therefore, if the “Vacation” function
has been already engaged, it has to be
disengaged first to activate the “Active
0” function (and viceversa).
REMOVING THE ACTIVE 0
COMPARTMENT
The Active 0 compartment can be
removed to create more space inside
the refrigerator. In this case proceed as
follows:
- switch o the compartment
- pull out the drawer
- pull out the glass shelf below Active 0
- remove the white plastic insulation
form the glass shelf
- put back the glass shelf.
Note: the upper shelf and the side supports
cannot be removed.
To restore Active 0
compartment box operation,
make sure you .replace the
white plastic shelf underneath
the box (with the glass shelf
assembled into the plastic)
before inserting the drawer
and reactivating the function. The Active
0 compartment satises the requirements
of a chill compartment according to EN
62552. Clean the compartment and all its
parts regularly, using a cloth and a solution
of warm water and neutral detergent
specically formulated for refrigerator
interiors (take care not to immerse the white
plastic shelf underneath the compartment in
water).
Before cleaning the box (including the
outside), remove the drawer so as to
disconnect the box from the electricity
supply.
Never use abrasive detergents.
ACTIVE 0
COMPARTMENT
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

Comments to this Manuals

No comments